1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
|
/* SPDX-License-Identifier: MIT */
/* SPDX-FileCopyrightText: 2023 Nicholas Chin */
#include <sys/mman.h>
#include <err.h>
#include <errno.h>
#include <fcntl.h>
#include <stdint.h>
#include <stdio.h>
#include <stdlib.h>
#include <unistd.h>
#include "accessors.h"
int get_fdo_status(void);
int check_lpc_decode(void);
void ec_set_fdo(void);
void write_ec_reg(uint8_t index, uint8_t data);
void send_ec_cmd(uint8_t cmd);
int wait_ec(void);
int check_bios_write_en(void);
int set_gbl_smi_en(int enable);
int get_gbl_smi_en(void);
#define EC_INDEX 0x910
#define EC_DATA 0x911
#define EC_ENABLE_FDO 2
#define LPC_DEV PCI_DEV(0, 0x1f, 0)
#define RCBA_MMIO_LEN 0x4000
/* Register offsets */
#define SPIBAR 0x3800
#define HSFS_REG 0x04
#define SMI_EN_REG 0x30
volatile uint8_t *rcba_mmio;
uint16_t pmbase;
int
main(int argc, char *argv[])
{
int devmemfd;
(void)argc;
(void)argv;
if (sys_iopl(3) == -1)
err(errno, "Could not access IO ports");
if ((devmemfd = open("/dev/mem", O_RDONLY)) == -1)
err(errno, "/dev/mem");
/* Read RCBA and PMBASE from the LPC config registers */
long int rcba = pci_read_32(LPC_DEV, 0xf0) & 0xffffc000;
pmbase = pci_read_32(LPC_DEV, 0x40) & 0xff80;
/* FDO pin-strap status bit is in RCBA mmio space */
rcba_mmio = mmap(0, RCBA_MMIO_LEN, PROT_READ, MAP_SHARED, devmemfd,
rcba);
if (rcba_mmio == MAP_FAILED)
err(errno, "Could not map RCBA");
if (get_fdo_status() == 1) { /* Descriptor not overridden */
if (check_lpc_decode() == -1)
err(errno = ECANCELED, "Can't forward I/O to LPC");
printf("Sending FDO override command to EC:\n");
ec_set_fdo();
printf("Flash Descriptor Override enabled.\n"
"Shut down (don't reboot) now.\n\n"
"The EC may auto-boot on some systems; if not then "
"manually power on.\n When the system boots rerun "
"this utility to finish unlocking.\n");
} else if (check_bios_write_en() == 0) {
/* SMI locks in place, try disabling SMIs to bypass them */
if (set_gbl_smi_en(0)) {
printf("SMIs disabled. Internal flashing should work "
"now.\n After flashing, re-run this utility "
"to enable SMIs.\n (shutdown is buggy when "
"SMIs are disabled)\n");
} else {
err(errno = ECANCELED, "Could not disable SMIs!");
}
} else { /* SMI locks not in place or bypassed */
if (get_gbl_smi_en()) {
/* SMIs are still enabled, assume this is an Exx10
* or newer which don't need the SMM bypass */
printf("Flash is unlocked.\n"
"Internal flashing should work.\n");
} else {
/* SMIs disabled, assume this is an Exx00 after
* unlocking and flashing */
set_gbl_smi_en(1);
printf("SMIs enabled.\n"
"You can now shutdown the system.\n");
}
}
return errno;
}
int
get_fdo_status(void)
{
return (*(uint16_t*)(rcba_mmio + SPIBAR + HSFS_REG) >> 13) & 1;
}
int
check_lpc_decode(void)
{
/* Check that at a Generic Decode Range Register is set up to
* forward I/O ports 0x910 and 0x911 over LPC for the EC */
int i = 0;
int gen_dec_free = -1;
for (; i < 4; i++) {
uint32_t reg_val = pci_read_32(LPC_DEV, 0x84 + 4*i);
uint16_t base_addr = reg_val & 0xfffc;
uint16_t mask = ((reg_val >> 16) & 0xfffc) | 0x3;
/* Bit 0 is the enable for each decode range. If disabled, note
* this register as available to add our own range decode */
if ((reg_val & 1) == 0)
gen_dec_free = i;
/* Check if the current range register matches port 0x910.
* 0x911 doesn't need to be checked as the LPC bridge only
* decodes at the dword level, and thus a check is redundant */
if ((0x910 & ~mask) == base_addr) {
return 0;
}
}
/* No matching range found, try setting a range in a free register */
if (gen_dec_free != -1) {
/* Set up an I/O decode range from 0x910-0x913 */
pci_write_32(LPC_DEV, 0x84 + 4 * gen_dec_free, 0x911);
return 0;
} else {
return -1;
}
}
void
ec_set_fdo(void)
{
/* EC FDO command arguments for reference:
* 0 = Query EC FDO status
* 2 = Enable FDO for next boot
* 3 = Disable FDO for next boot */
write_ec_reg(0x12, EC_ENABLE_FDO);
send_ec_cmd(0xb8);
}
void
write_ec_reg(uint8_t index, uint8_t data)
{
sys_outb(EC_INDEX, index);
sys_outb(EC_DATA, data);
}
void
send_ec_cmd(uint8_t cmd)
{
sys_outb(EC_INDEX, 0);
sys_outb(EC_DATA, cmd);
if (wait_ec() == -1)
err(errno = ECANCELED, "Timeout while waiting for EC!");
}
int
wait_ec(void)
{
uint8_t busy;
int timeout = 1000;
do {
sys_outb(EC_INDEX, 0);
busy = sys_inb(EC_DATA);
timeout--;
usleep(1000);
} while (busy && timeout > 0);
return timeout > 0 ? 0 : -1;
}
int
check_bios_write_en(void)
{
uint8_t bios_cntl = pci_read_32(LPC_DEV, 0xdc) & 0xff;
/* Bit 5 = SMM BIOS Write Protect Disable (SMM_BWP)
* Bit 1 = BIOS Lock Enable (BLE)
* If both are 0, then there's no write protection */
if ((bios_cntl & 0x22) == 0)
return 1;
/* SMM protection is enabled, but try enabling writes
* anyway in case the vendor SMM code doesn't reset it */
pci_write_32(LPC_DEV, 0xdc, bios_cntl | 0x1);
return pci_read_32(LPC_DEV, 0xdc) & 0x1;
}
int
set_gbl_smi_en(int enable)
{
uint32_t smi_en = sys_inl(pmbase + SMI_EN_REG);
if (enable) {
smi_en |= 1;
} else {
smi_en &= ~1;
}
sys_outl(pmbase + SMI_EN_REG, smi_en);
return (get_gbl_smi_en() == enable);
}
int
get_gbl_smi_en(void)
{
return sys_inl(pmbase + SMI_EN_REG) & 1;
}
|
